ND-70348 (E) CHAPTER 4
Page 604-1
Revision 4.0
ACNAL
ACNAL:
Assignment of Calling Number Pattern Data per Access Code (LDM)
1. General
This command is used to assign the Calling Number Pattern (CNP) on an access code basis. CNP is used for the
SID to Network-Present service and for the Calling Party Recognition service. The data assigned by this com-
mand is written in Local Data Memory (LDM).
2. Precautions
1. The CNP parameter in this command corresponds to the one assigned by the ACND command.
2. This command is available since Release 10 software enhancement.
3. Data Entry Instructions
ROUTE
NUMBER
(RT)
INCOMING
OR
OUTGOING
(IC/OG)
ACCESS CODE
(ACC)
MAX. 16 DIGITS [0-9, *, #]
CALLING
NUMBER
PATTERN
(CNP)
1-255
DIALED NUMBER
CONFIRMATION
(DC)
1-7
REMARKS
Assign an access code for
specifying the destination.
ACC
Further data assignment by using the ACND command
is required. (This parameter is required for “OG”.)
CNP
DC
Assign the number of digits for specifying called station number
(used for Direct Inward Dialing-in (DID) Addressing). This data
setting has precedence over that of CDN66 (DC) -ARTD
command. (This parameter is required for “IC”.)
IC
OG
To Next Page
Loading...
Need help?
General