ND-70348 (E) CHAPTER 4
Page 680
Revision 3.0
ALGNN
ALGNN: Assignment of Telephone Number Data for NDM
1. General
This command is used to assign the Telephone Number (TELN) for the individual attendant identification. The
data assigned by this command is written in Network Data Memory (NDM) of the Network Control Node
(NCN), updating the NDM at each Local Node (LN).
2. Precautions
1. The applicable tenant number (TN) range is designated by the ASYDN command, SYS 1, INDEX 8. If the
numbering plan is common for all tenants (ASYDN, SYS1, INDEX 800, bit0=1), assign TN parameter as
“1” for all tenants.
2. The system data assignment (ASYDN, SYS 1, INDEX 514, bit1=1) is needed to provide the Network Data
Memory (NDM).
3. Before assigning this command, ANPDN / ASPAN commands are required for the numbering plan of the
Telephone Number (TELN).
4. A unique Telephone Number (TELN) should be given within a User Group Number (UGN).
5. For more detail, see the “Netfusing System Manual”.
3. Data Entry Instructions
USER GROUP
NUMBER(UGN)
TELEPHONE STATION NUMBER (TELN)
MAX. 16 DIGITS
REMARKS
1 40000
1 40001
1 40002
UGN
Fixed “1”
TELN
Assign Telephone Number (Unique TELN should
be given within a UGN)
To Next Page
Loading...
