NEC NEAX 7400 IMX User Manual

ND-70348 (E) CHAPTER 4
Page 679
Revision 3.0
ASPAN
Assign a dummy route number.
LGRT
Second dial tone sending (which is sent when a station has
dialed the digits specified in NND of the ANPDN command)
0=Second DT is not send
1=Second DT is sent
2nd DT
Authorization code after dialing
ACC(LCR)+Destination number
0=Out of Service
1=In Service
AH
ISDN-Sub Address Dialing
0=Out of Service
1=In Service
SUB
LOGICAL ROUTE
NUMBER (LGRT)
SECOND DIAL TONE
(2nd DT) 0/1
AUTHORIZATION CODE
(AH) 0/1
SUB ADDRESS DIALING
(SUB) 0/1
When SRV=LCR (Least cost routing) is assigned;
When SRV=LCRS (Register sender LCR) is assigned;
MAXIMUM NUMBER OF DIGIT
(NND) 1-16
When SRV=TELN (Telephone Number)
LOGICAL ROUTE NUMBER
(LGRT) 1-899
When SRV=PAGA (Paging Answer) is assigned;
When SRV=PAGC (Paging Cancel) is assigned;
LGRT
Enter the Logical Route Number of
Paging Trunk.
Assign the announce equipment number.
See Table 4-6 .
When SRV=ANNC (Announcement service) is assigned;
ANNOUNCEMENT EQUIPMENT NUMBER
(EQP) 0-127 EQP
Assign the tenant
number of the
announcement trunk.
When SRV=ANNCM (Announcement service-Multiple announcement) is assigned;
TN
TENANT NUMBER
(TN) 1-63
ANNOUNCEMENT EQUIPMENT NUMBER
(EQP) 122-125
Assign the announcement equipment
number with a range from 122 to 125
(Multi announcement).
EQP
(page 238)

NEC NEAX 7400 IMX Specifications

General

Brand	NEC
Model	NEAX 7400 IMX
Category	Server
Language	English