ND-70348 (E) CHAPTER 4
Page 678
Revision 5.0
ASPAN
Table 4-30 SID (ASPAN)
Note:
The access code for the services marked * on Table 4-30 and Table 4-31 must be assigned with the same
number of digit if the access code begins using the same number. It is not available to assign different num-
ber of digit for the access codes (i.e. access code “100” and “10” cannot co-exist) in these services.
Table 4-31 SIDA (ASPAN)
SID SERVICE NAME SID SERVICE NAME
1 – 21-36 –
2 Dial Access to Attendant (Operator Call) 37* Priority Call 1
3 Camp on By Station 38* Priority Call 2
4-6 – 39* Priority Call 3
7 Call Pickup - Group 40-60 –
8-18 – 61 Call Park; Entry
19 OG Trunk Queuing; Entry 62 Call Park; Local Retrieve
20 OG Trunk Queuing; Cancel 63 Call Park; Remote Retrieve
SIDA SERVICE NAME SIDA SERVICE NAME
1-49 –
118 *
Calling Party CLIR/CLIP Control
Note:
Valid since Release 8 for Australia only.
50 UCD Busy Out; Entry *
51 UCD Busy Out; Cancel * 119 –
52-62 – 120 Selectable Station Call Pickup
63 Call Pickup Expand 121 Selectable Station Call Pickup Group
64-97 – 122 –
98
Internal Zone Paging; Originate
Note:
Valid since Release 9
123 IP Enabled Dterm Password Entry (for IPX)
99-117 – 124-255 –
SERVICE INDEX A (SIDA) 1-255
When SRV=SSCA (Service code appendix) is assigned;
SIDA
Refer to Table 4-31 SIDA (ASPAN).
Note: Only 50, 51, 63 are available for the software Release 3.
LOGICAL ROUTE NUMBER
(LGRT)
When SRV=OGC (Outgoing call) is assigned;
CNT (1-15) LOGICAL ROUTE NUMBER (LGRT)
When SRV=OGCA (Outgoing call with route advance) is assigned;
CNT
CNT is the route advance order.
1
2
3
To Next Page
Loading...
Need help?
General