ND-70348 (E) CHAPTER 4
Page 560
Revision 3.0
ACFS_T
ACFS_T: Assignment of Call Forwarding Station Data – Telephone Number
1. General
This command is used to set the Call Forwarding - All Calls/Busy Line/Don’t Answer, and further the Split Call
Forwarding Services for each station. The station data of ACFS command can be assigned by using Telephone
Number instead.
2. Precautions
1. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the
ALGSL command is not available in this command.
2. In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in
node can be used in this command. Also, when logging in to the NCN, the data memory of the whole
nodes in the network is to be written.
3. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8.
4. The “RCV” parameter can be assigned when ASYD, SYS1, INDEX79, b2=1 (Split Call Forwarding is In
Service), and “Split Call Forwarding” is selected in “TYPE” parameter.
5. This command is available since Release 8 software enhancement.
3. Data Entry Instruction
Note: The existing data is readout by pressing “Get” button after UGN and TELN is entered.
UGN
CALL
FORWARDING
TYPE
(TYPE)
CALL
FORWARDING
KIND
(SRV)
KIND OF
RECEIVED
CALL
(RCV)
TELEPHONE NUMBER
(TELN)
Max. 16 digits
CALL FORWARDING
DESTINATION
NUMBER
(CFD)
Max. 24 digits
TELN
Enter the Telephone Number of the station
to which this service is to be assigned.
CFD
Enter the call forwarding destination
number within 24 digits.
TYPE
Select the type of Call Forwarding.
Call Forwarding
Split Call Forwarding
SRV
Select the kind of Call Forwarding.
All Calls
Busy Line
Don't Answer
• PS Incoming Incomplete
RCV
When "Type = Split Call Forwarding" is
entered, select the kind of received call.
Trunk
Telephone Number
To Next Page
Loading...
