ND-70348 (E) CHAPTER 4
Page 335
Revision 3.0
ALGSL
ALGSL: Allocation of Telephone Station Data for LDM
1. General
This command is used to assign the data pertaining to the relationship between the Telephone Station Number
(TELN) and the physical station.
2. Precautions
1. This Telephone Number can be used in the self (local) node only. Use the ALGSN command if the Tele-
phone station Number for the Netfusing Network is required.
2. The TYPE parameter designates the programming method of the physical station. (The result is the same
whichever method is selected.) When TYPE = 1 (LENS) is selected, the physical station which accommo-
dates the Telephone Station Number (TELN) is specified by the LENS. When TYPE = 2 (STN) is selected,
the physical station number (STN) is used.
3. The system data assignment (ASYDL, SYS1, INDEX513 Data 01hex) is needed to provide the Local Data
Memory (LDM).
4. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8. If data
in this command is common for all tenants (ASYDL command, SYS1, INDEX800, bit0 = 1), assign TN
parameter as data “1” for all tenants.
To Next Page
Loading...
Need help?
General