ND-70348 (E) CHAPTER 4
Page 618
Revision 3.0
AEVT
AEVT: Assignment of Virtual Tie Line Data for Event Based CCIS
1. General
This command is used to assign Virtual Tie Line data for Event Based CCIS.
2. Precautions
1. When the parameter VRY (Verification of Connection) is assigned as “1”, if the Calling party number is
not the same as the number assigned in the parameter CALLED, connection is not established.
2. This command can be used in the software Release 2 or later.
3. Data Entry Instructions
♦ When FUNC=1 (Virtual tie line data is set for each route) and TYPE=1/2 are assigned
TYPE
1=Separate Channel System
2=Separate Channel System (for Call-By-Call)
3=Common Channel System
4=Common Channel System (When NPI and
TON are assigned by the ACBC command)
DESTINATION
E-CCIS trunk
identification number.
OPR
Assign Outgoing Route
Selection pattern number.
RA
Assign the order of
route advancing.
CALLED
CALLED NUMBER
(CALLED)
1-24
CCIS_RT
1-255
CCIS_TK
1-255
VRY
0/1
OPR
1-4000
RA
0-7
DID number for
outgoing call
CALLING
DID number for incoming
call from an E-CCIS
CCIS_RT/CCIS_TK
Assign CCIS signal route and
trunk number.
VRY
Verification of connection
0=Not required
1=Required
Note 1: OPR and RA parameters appear for TYPE=2.
FUNCTION
ROUTE
NUMBER
(RT)
1-255
TRUNK
NUMBER
(TK)
1-255
DESTINATION
NUMBER
(DESTINATION)
6 DIGITS
CALLING NUMBER
(CALLING)
1-24
TYPE
1-4
1
To Next Page
Loading...
Need help?
General