NEC NEAX 7400 IMX - Page 643

ND-70348 (E) CHAPTER 4
Page 619
Revision 3.0
AEVT
♦ When FUNC=1 (Virtual tie line data is set for each PC) and TYPE=3/4 are assigned
♦ When FUNC=2 (E-CCIS RT is set for each Terminating PC)
TYPE
1=Separate Channel System
2=Separate Channel System (for Call-By-Call)
3=Common Channel System
4=Common Channel System (When NPI and
TON are assigned by the ACBC command)
DESTINATION
E-CCIS trunk
identification number.
OPR
Assign Outgoing Route
Selection pattern number.
RA
Assign the order of
route advancing.
CALLED
CALLED NUMBER
(CALLED)
1-24
ISDN_RT
1-255
VRY
0/1
OPR
Note 2
1-4000
RA
Note 2
0-7
DID number for
outgoing call
CALLING
DID number for incoming
call from an E-CCIS
ISDN_RT
Assign ISDN Dch’s route
VRY
Verification of connection
0=Not required
1=Required
Note 2: OPR and RA parameters appear for TYPE=4.
FUNCTION
ROUTE
NUMBER
(RT)
1-255
TRUNK
NUMBER
(TK)
DESTINATION
NUMBER
(DESTINATION)
6 DIGITS
CALLING NUMBER
(CALLING)
1-24
TYPE
1-4
10
TK
Fixed 0 .
FUNCTION
POINT CODE
(PC)
1-16367
ROUTE NUMBER
(RT)
1-255
2
RT
Enter the E-CCIS
route number
PC
Enter PC of the
terminating node.