NEC NEAX 7400 IMX - AARP: Assignment of Area Code Restriction Data

ND-70348 (E) CHAPTER 4
Page 304
Revision 3.0
AARP
AARP: Assignment of Area Code Restriction Data
1. General
This command is used to assign the area/office code of Toll Restriction - 3/6 digits conjunction with ATDP com-
mand.
2. Precautions
1. This command is used when restriction data is assigned to RES=2 (Toll Restriction is required) in the
ARSC command or in the ARRC command.
2. This command is available since Release 7.5 software enhancement.
3. Data Entry Instructions
Note: In case the data has already been assigned when “Get” button is executed after checking “6 Digits” pa-
rameter and entering DC=000000, “Del” button is not valid while “Set” button is to be effective. Then the
restriction data can be changed (overwritten) by “Set” button.
OUTGOING
ROUTE
NUMBER
(OGRT)
ROUTE
RESTRICTION
CLASS(RSC)
0-15
FLAG OF 3 OR
6 DIGITS
(FLAG)
3 Digits/6 Digits
DESTINATION
(AREA/OFFICE)
CODE (DC)
MAX .6 DIGITS
RESTRICTION
DATA (RES) 0/1
REMARKS
FLAG
Select either "3 Digits" or
"6 Digits" check box.
RES
0 = Area/Office code is restricted.
1 = Area/Office code is allowed.
DC should not include the access code.
DC
RSC assigned by the ARSC command.
RSC