ND-70348 (E) CHAPTER 4
Page 294
Revision 3.0
ARSCN
ARSCN: Assignment of Route Restriction Class for NDM
1. General
This command is used to assign route restriction information according to the Route Restriction Class (RSC) of
the station and the Logical Route Number in the Netfusing network.
2. Precautions
1. Data can be entered on a Day/Night basis, if specified in ASYDN command, SYS1, INDEX75, bit 0=1.
2. The applicable tenant number (TN) range is designated by the ASYDN command, SYS1, INDEX8. If data
of this command is common for all tenants (ASYDN command, SYS1, INDEX800, bit6=1), assign TN pa-
rameter as data “1” for all tenants.
3. The displayed RSC (Route Restriction Class) corresponds to the one assigned by the ASDT command.
4. The details of each RRI are;
Note: For the dummy route, assign the data to RRI3 only.
5. The restriction data (RES) is entered in the text box where RSC and RRI cross.
6. When RES=2 is assigned in RRI=3, ATDPN/AARPN (Toll Restriction 3/6 digits) should be assigned to
specify the connection allowed area.
7. The parameter “RES” = 2 (Toll Restriction is allowed) is valid only when the parameter “RRI” = 3 (OG
Restriction Directly) is assigned.
RRI Descriptions
RRI-0 Trunk incoming connection with an Attendant Console (or a station) assistance.
RRI-1 Trunk incoming connection without assistance.
RRI-2 Trunk outgoing connection with an Attendant Console (or a station) assistance.
RRI-3 Trunk outgoing connection without assistance. Note
To Next Page
Loading...
Need help?
General