ND-70348 (E) CHAPTER 4
Page 315
Revision 3.0
ACFR
ACFR: Assignment of Call Forwarding Restriction
1. General
This command is used to assign various kinds of trunk call forwarding restriction data on a tenant basis.
2. Precautions
1. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8.
If data of this command is common for all tenants (ASYD command, SYS1, INDEX92, bit5=1), assign TN
parameter as data “1” for all tenants.
3. Data Entry Instructions
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
1
2
3
4
5
1
RESTRICTION DATA(RES) is assigned in the squares where CCI
and TSFI cross.
0=Transfer service is restricted.
1=Transfer service is allowed.
RES
CCI
0 =Attendant Call 1 = LDN (C.O. Line)
2 = DDD2 3 = DDD3
4 = Tie Line 5 = DDD4
6 = Recall
7 = Call Forwarding-Busy Line
8 = Call Forwarding-Don't Answer
9 = Not used
10 = Special common Battery
11 = Inter Position Transfer
12 = Priority call
13 = Off Hook Alarm 14 = CAS (Main)
15 = Not used
TRANSFER
SERVICE
FEATURE
INDEX
(TSFI) 1-15
TENANT
NUMBER
(TN)
CALL CATEGORY INDEX (CCI) 0-15
TSFI
1 = Call Forwarding (-All Calls/-Don't Answer/
-Busy Line/Unused Number/Dead Level)
2 = Direct in Termination(Night only)
3 = Direct in Termination(Day and Night)
4 = Direct Inward Dialing(DID)
5 = TAS 6 = Night ATT
7 = Remote Access to System
8-14 = Not used
15 = CAS Line connection(Satellite)
To Next Page
Loading...
Need help?
General