NEC NEAX 7400 IMX - AFPC: Assignment of FCCH Routing Data for LDM

ND-70348 (E) CHAPTER 4
Page 633
Revision 3.0
AFPC
AFPC: Assignment of FCCH Routing Data for LDM
1. General
This command is used to assign the B-channel and the D-channel data for each FPC.
2. Precautions
1. The maximum number of alternative connection trunks is 8 for 1 FPC.
2. The maximum number of the alternative FCH cards is 8 for 1 destination FPC. (In Netfusing Link using
the FCH card.)
3. The maximum number of the alternative FPCs is 8 for 1 destination FPC. (In Netfusing Link using the
LANI card.)
4. When FCCH = 0 (The FCH card is not used), assign the Fusion Point Code Number of the final destination
to the parameter FPCN.
5. When FCCH = 1 (The FCH card is used), assign the FCCH number to the parameter “FCHN”.
6. For more detailed information, see the “Netfusing System Manual”.