ND-70348 (E) CHAPTER 4
Page 578
Revision 4.0
ACSIL
ACSIL: Assignment of Connection Service Index Data for LDM
1. General
This command is used to assign the call termination for Direct-in Termination (Day and Night), Night Connec-
tion and Remote Access to System for the Local Node (LN) in Netfusing Network.
2. Precautions
1. The ACFR command assignment is also required to assign the trunk incoming call termination service fea-
ture.
2. When setting the CSI to "6" (Night Connection-Outside) or "7" (Direct-in Termination-Outside) using this
command, the ADC must be set by the ASPD command.
3. Use the ACSAL command instead of this command if Direct-in Termination (Day mode only) is required.
4. When the “PFT control by the external key” is required, the following data assignments are needed:
(a) AUNT command, TYPE=2 (PFT)
(b) AEKD command
(c) ANCD command
(d) ACSIL command, CSI=4 (Direct-in Termination (Night Mode))
Note
Note:
If CSI=4 “Direct-In Termination (Night Mode)” is to be assigned in the ACSIL command, CCI=1 & CCI=4
for TSFI=2 must be set to data “1 (allowed)” in the ACFR command.
To Next Page
Loading...
