ND-70348 (E) CHAPTER 4
Page 587
Revision 3.0
AANI
AANI: Assignment of ANI Data
1. General
This command is used to assign ANI (Automatic Number Identification) data sent per tenant by the request from
opposite office.
2. Precautions
1. Before using this command, ASYD SYS1 INDEX 125 b4 - b7 (Type of MFC Signaling System) should
be assigned.
2. When ASYD command, SYS 2 INDEX 15, b2 = 1, the following number is sent as ANI data.
(a) Calling party is a station:
Calling party’s station number is sent.
(b) Calling party is an Attendant or tandem connection:
“LDN” assigned in this command is sent.
If b2 = 0, “LDN” assigned in this command is sent.
3. The ANI parameter of ARTD command should be assigned prior to this command.
4. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.
3. Data Entry Instructions
NUMBER
(TN)
TENANT
CALL NUMBER OF TOLL
(TS)
MAXIMUM 8 DIGITS
LISTED DIRECTORY
NUMBER(LDN)
MAXIMUM 8DIGITS
If no LS (Local Number) of ANI is required,
enter "*" or "#" in this parameter.
The LS is not included in ANI.
LS
CALL NUMBER OF LOCALL
(LS)
MAXIMUM 8 DIGITS
REMARKS
TS
This paramenter is not used. (For China only)
Press SPACE key and Enter key in order to skip
this parameter.
To Next Page
Loading...
Need help?
General