ND-70348 (E) CHAPTER 4
Page 523
Revision 3.0
ASHUN
ASHUN: Assignment of Station Hunting Group-UCD for NDM
1. General
This command is used to assign the data related to the Uniform Call Distribution (UCD) for Netfusing Service.
The data assigned by this command is written in the Network Data Memory (NDM) of the Network Control
Node (NCN), updating the NDM at each Local Node (LN).
2. Precautions
1. This command is also used to modify and delete the UCD service related data.
2. The maximum number of stations within a UCD group is 100.
3. The UCD pilot station (controlling station) is assigned at the TELN parameter.
4. Press ESC to skip forward to the WRT? text box when all the desired stations have been entered.
5. Assign the AUADN command if the Delay Announcement-UCD service feature is required.
6. Assign the AUCDN command if the peripheral threshold as listed below is required:
(a) The number of call in UCD queuing which is used for the UCD Peg Count
(b) The threshold of the UCD Call Waiting Lamp (which accommodated on a D
term
) starts to flash
(c) Denial of the MCI call result text of the call terminated to the UCD group
7. Assign AUOGN command if the Overflow-UCD service feature is required.
8. When assigning the AUADN/AUCDN/AUOGN commands, the User Group Number (UGN) and the UCD
Pilot station (controlling station) number (TELN) assigned in this command are used to specify the UCD
group.
To Next Page
Loading...
Need help?
General