ND-70348 (E) CHAPTER 4
Page 505
Revision 3.0
ARTIN
ARTIN: Assignment of Trunk Application Data for NDM
1. General
This command is used to assign/delete trunk application data in Netfusing system. The data assigned by this
command is written in the Network Data Memory (NDM) of the Network Control Node (NCN), updating the
NDM at each Local Node (LN).
2. Precautions
1. This command can be used only when logging in to NCN (Network Control Node).
2. The data assigned by this command is also allocated to the Trunk Application data for physical route (AR-
TI). If the Trunk Application data is deleted by using this command, however, the data for physical route
is not to be deleted. Therefore, use ARTI command to invalidate the Trunk Application Data for physical
route.
3. Data Entry Instructions
See Data Sheet on the following pages.
To Next Page
Loading...
Need help?
General