ND-70348 (E) CHAPTER 4
Page 601
Revision 3.0
ACDD
ACDD: Assignment of Change Digit Code for Dial in Service
1. General
This command is used to assign the Change Digit Code for the ISDN line with DID Addressing.
2. Precautions
1. Data can be entered on a Day/Night basis if specified in ASYD command, SYS 1, INDEX 75, Bit 5=1.
2. This command does not affects if DC = 0 (Sub Address - Addressing) is assigned by the ARTD command.
3. Enter the B-Channel Route Number in the parameter “RT”.
3. Data Entry Instructions
REMARKS
DAY/NIGHT
MODE
(DAY/NIGHT)
D/N
ROUTE
NUMBER
DIGIT CODE(DC)
MAX. 7 DIGITS
CHANGE DIGIT CODE(CDC)
MAX.24 DIGITS
ADDITIONAL
DIALING
(AD)
FORWARDING
DATA
(XER)
DAY/NIGHT
D = Day
N = Night
DC
Max.7 digits
Number of digits for this DC
must match the data in DC of
the ARTD command
RT
Enter the B-Channel Route Number
in the parameter "RT".
XFR
Always assign data "0" in XFR parameter
when ISDN DID Addressing is provided.
0 = Transfer is in service
1 = Transfer is out of service
AD
Always assign data "0" in AD parameter when ISDN DID
Addressing.
0 = Additional Dialing Service is out of service.
1 = PBX dial-in Additional Dialing Service (Japan) is in service.
D10
2411
3611
0
0
(RT)
0/1 0/1
To Next Page
Loading...
Need help?
General