ND-70348 (E) CHAPTER 2
Page 32
Revision 3.0
HOW TO OPERATE MAT
6. Configuring IMX MAT
This section explains the PBX Alias parameters you may configure using the PBX Administration dialog window.
It also lists the default values of NEAX-IMX, the default PBX Alias delivered with the IMX MAT software. Prior
to running the IMX MAT, you should either define a new PBX Alias, configure the default PBX to work with your
system, or plan to use the NEAX-IMX default Alias. NEAX-IMX is ready for use once the IMX MAT software has
been successfully installed. Table 2-3 lists the default values displayed in the PBX Administration dialog box when
you select NEAX-IMX as your PBX Alias.
6.1 Serial/Direct Connection
The following steps explain how to configure the PBX Alias for a serial/direct connection using the recommended
default data.
Note: You can use other data when configuring IMX MAT. However, it is recommended that you use the default
data as previously described when configuring a new PBX Alias.
Table 2-3 PBX Administration Default Values
PBX Alias NEAX-IMX
Connection Type Serial/Direct
FPC 1
Connect 120000
Response Timeout 120000
Pacing Timer 10000
Link Data Log Path blank
COM Port COM 1
Baud Rate 4800
Ignore CTR blank
Ignore DSR blank
Modem Name blank
Phone Number blank
Host Name blank
IP Address 172.16.253.0
TCP Port 60000
Inter-App Resource blank
To Next Page
Loading...
