NEC NEAX 7400 IMX User Manual

ND-70348 (E) CHAPTER 4
Page 465
Revision 3.0
ASATN
ASATN: Assignment of Specific Attendant Number Data for NDM
1. General
This command is used to assign a specific Attendant Number which allows a station user to access the desired
operator. The data assigned by this command is written in the Network Data Memory (NDM) of the Network
Control Node (NCN), updating the NDM at each Local Node (LN).
2. Precautions
1. The specific attendant number cannot be a station number or LDN already being utilized.
2. The maximum number of Attendant Consoles should be assigned by the ASYDN command, SYS 1, IN-
DEX 9.
3. The telephone number for specifying the attendant console must be assigned by the ALGNN command pri-
or to this command.
3. Data Entry Instructions
FPC
Enter the FPC of the node accommodating the
specified attendant console.
ACC
Enter the telephone number for special
attendant number assigned by the ALGNN
command.
ATN
Enter the ATN which corresponding
to the TK parameter for the attendant
console assigned by the ATRK
command.
UGN
Fixed “1”.
USER
GROUP
NUMBER
(UGN)
FUSION
POINT CODE
(FPC)
1-253
TENANT
NUMBER
(TN)
ATTENDANT
NUMBER
(ATN)
ACCESS CODE (ACC)
MAXIMUM 16 DIGITS
TN
Enter the tenant number which affects
the special attendant number.
1
1
1

NEC NEAX 7400 IMX Specifications

General

Brand	NEC
Model	NEAX 7400 IMX
Category	Server
Language	English