ND-70348 (E) CHAPTER 4
Page 314
Revision 5.0
ASFC
Table 4-8 SFI (4/4)
Note 1:
This data is available since Release 8 software enhancement.
Note 2:
This data is available since Release 9 software enhancement.
Note 3:
Only the outgoing call from ATTCON to MFC line is used to send out G-II signal with the combination of SFIs as
follows:
SFI88
SFI89
SFI91
SFI92
SFI159
•
Attendant Console without a held station/trunk
•
Attendant Console with held station
•
Attendant Console with held trunk
•
Individual Trunk Access from Attendant Console
For more detail explanations, refer to MFC Signaling Programming Manual.
Note 4:
This data is available since Release 10 software enhancement.
Note 5:
This data is available since Release 11 software enhancement (for IPX system only).
SFI SERVICE FEATURE
159 Category of Attendant
160-162 -
163 ANI demand per station
Note 4
164-171 -
172 Calling Party CLIR/CLIP Control (for Australia only)
Note 1
173 -
174 Camp On By Station (since Release 7 for Australia, Release 9 for other countries)
175 Advice of Charge Supplementary Service in Q.SIG Network
Note 1
176-180 -
181 Station Hunting by Call Kind
Note 2
182 -
183 Selectable Station Call Pickup
Note 4
184-185 -
186 IP Enabled D
term
Login
Note 5
187-255 -
Category of Attendant
To Next Page
Loading...
Need help?
General