ND-70348 (E) CHAPTER 4
Page 766
Revision 3.0
AGSPL
Note: Note that this Telephone Number is available to make a call and receive a call within the self node only.
If the Telephone Number is to be used within the Netfusing Network, assign it at Network Control Node
(NCN) by using the ASPAN command.
Assign the skip digits to terminate the call.
Assign the announce equipment number.
EQP3 and 5-14 can be used for SRV=ANNC (Single announcement).
SKIP DIGITS
(SKIP) 0-5
When SRV=UNIF (Office termination) is assigned:
When SRV=ANNC (Announcement service-Single announcement) is assigned;
SKIP
ANNOUNCEMENT EQUIPMENT NUMBER
(EQP) 0-127
EQP
Note: This data is available for ACIS only. For CCIS, use the AUNE command.
Assign the tenant number of
the announcement trunk.
When SRV=ANNCM (Announcement service-Multiple announcement) is assigned;
TN
TENANT NUMBER
(TN) 1-255
ANNOUNCEMENT EQUIPMENT NUMBER
(EQP) 122-125
Assign the announcement equipment number
range from 122 to 125 (Multi announcement).
EQP
When SRV=TELN (Telephone Number)
NECESSARY DIGIT
(NND) 1-16
To Next Page
Loading...
Need help?
General