ND-70348 (E) CHAPTER 4
Page 530
Revision 3.0
AUCDN
3. Data Entry Instructions
Enter the maximum number of calls in the
UCD queuing.
(When the number of incoming call exceeds
this value, the caller hears Busy Tone.)
QTH
Enter the number of calls in the UCD queue.
(This value is used for UCD Call Waiting Lamp on D
term
)
CWT
TELEPHONE
NUMBER
(TELN)
UCD
QUEUING
PEG COUNT
VALUE
(QTH ACT) 0/1
UCD
QUEUING
PEG COUNT
VALUE
(QTH ) 0-255
THRESHOLD
VALUE OF
CALL WAITING
(CWT)
1-255
MCI DATA
TRANSFER
(MCI)
0/1
USER
GROUP
NUMBER
(UGN)
UGN and TELN
QTH ACT
UCD queuing value is:
0 = Invalid (QTH parameter is not assigned)
1 = Valid (QTH parameter is assigned)
MCI
The call record to the UCD group
is transferred to MCI
0 = Valid 1 = Invalid
UGN and TELN (UCD pilot station number) parameters should be assigned with respect to the data assigned by the ASHUN
command.
To Next Page
Loading...
Need help?
General