ND-70348 (E) CHAPTER 4
Page 351
Revision 3.0
AKYD_T
9. A virtual line can be assigned as a Sub Line of the D
term
. The virtual line can be used the same way as the
My Line for outgoing calls and other service operations. Note
Note: Virtual Line --- A virtual LENS exists only in memory, but does not exist physically. Data can be assigned
but no hardware is required.
Example: LENS = 000311. The virtual LENS is assigned by the ASDT command in the same way as an ordinary
line. (The telephone class is TEC = 18: Virtual Line)
10. If the station user accepts the default settings, the data assignment of this command is not required. The
default data for each line/feature button is shown below.
Table 4-15 Default Data for Each Line/Feature Button
11. The ability to assign Sub Line appearances across module groups is available when ASYD command
SYS1, INDEX321, bit0 = 1 is assigned. Stations can appear on D
term
which accommodated the different
module group within the same IMG.
12. When assigning the line/feature buttons as function keys, take the following precautions:
(a) My Line key must be programmed.
(b) Not used line/feature buttons should be assigned as KYI = 0 (Not used)
(c) The following function keys are basically fixed:
FKY = 13: CONF (Three - Way Calling)
FKY = 18: TRANSFER (Call Transfer - All Calls)
FKY = 20: HOLD (Non - Exclusive Hold/Exclusive Hold)
FKY = 28: ANSWER
FKY = 51: MIC
FKY = 52: SPEAKER
FKY = 57: RECALL
KEY
NO.
DEFAULT DATA
KEY
NO.
DEFAULT DATA
1 CALL PICKUP 9 PRIME LINE
2 CALL FORWARDING - BUSY LINE 10 SPEED CALLING ONE-TOUCH
3
CALL FORWARDING - ALL CALLS
CALL FORWARDING - DON’T ANSWER
11 SPEED CALLING ONE-TOUCH
4 EXECUTIVE RIGHT OF WAY 12 SPEED CALLING ONE-TOUCH
5 VOICE CALL 13 SPEED CALLING ONE-TOUCH
6 MESSAGE REMINDER 14 SPEED CALLING ONE-TOUCH
7 SAVE AND REPEAT 15 SPEED CALLING ONE-TOUCH
8 LAST NUMBER CALL 16 SPEED CALLING - SYSTEM
To Next Page
Loading...
