NEC NEAX 7400 IMX

To Next Page

To Previous Page

ND-70348 (E) CHAPTER 4

Page 352

Revision 3.0

AKYD_T

13. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8.

14. There is no default key data provided for D

term

(8-button type). The key data for all the line/feature but-

tons must be programmed. When assigning the key data of the line/feature button, take the following pre-

cautions:

(a) My Line Key must be assigned in KYN = 1-8, and KYN = 9-16 should be assigned KYI = 0 (Not

used).

(b) The following function keys are basically ﬁxed:

FKY = 13:CONF (Three-Way Calling)

FKY = 18:TRANSFER (Call Transfer-All Calls)

FKY = 20:HOLD (Non-Exclusive Hold/Exclusive Hold)

FKY = 28:ANSWER

FKY = 51:MIC

FKY = 52:SPEAKER

FKY = 57:RECALL

15. There is no default key data provided for D

term

(24-button type/32-button type). The key data for all of the

line/feature buttons must be programmed. When assigning the key data of the line/feature button, take the

following precautions:

(a) My Line Key must be assigned in KYN = 1-24, and KYN = 25-40 should be assigned KYI = 0 (Not

used).

My Line in KYN = 17-24 cannot be assigned without assigning any Line Key or any Function Key in

KYN = 1-16.

(b) The following function keys are basically ﬁxed.