EasyManuals Logo

NEC NEAX 7400 IMX User Manual

NEC NEAX 7400 IMX
857 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #556 background imageLoading...
Page #556 background image
ND-70348 (E) CHAPTER 4
Page 539
Revision 3.0
AUADN
3. Data Entry Instructions
74.
NUMBER OF
ANNOUNCEMENT
TRUNK
(CNT)
1-8
CONTROLLING
STATION
ANNOUNCEMENT
TRUNK
UGN and TELN
DLYT
Enter the delay timer value in second with a range of 0-
30 seconds. (2 seconds increments)
UGN is fixed to "1".
Enter the TELN (NDM) of the UCD pilot station with respect to the data assigned by the ASHUN
command.
1
2
MSGT
RP
Announcement replay
0 = Once
1 = Repeat within the time specified by the INT parameter
INT
The INT parameter is appeared when RP = 1.
Enter the replay interval time value in seconds with a range
of 0-30 seconds. (2 seconds increments)
CNT
The number of external trunks to be
connected to an external
announcement machine.
LGRT
Enter the Logical Route Number of the Announcement
Trunk. (Announcement Trunk should be mounted on the
same node in which the UCD pilot station is
accommodated.
DELAY
TIMER
(DLYT)
0-30
TRUNK
NUMBER
(TK)
LOGICAL
ROUTE
NUMBER
(LGRT)
MESSAGE
TIMER
(MSGT)
0-30
ANNOUNCE-
MENT
OUTPUT
REPLAY
(RP)
0/1
REPLAY
INTERVAL
(INT)
0-30
USER
GROUP
NUMBER
(UGN)
TELE-
PHONE
NUMBER
(TELN)
Enter the message timer value in seconds within 0-30 seconds.
(2 seconds increments)
However, this value is not effective if the Route data of Announcement
Trunk is assigned as follows:
ARTDN ANS=1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC NEAX 7400 IMX and is the answer not in the manual?

NEC NEAX 7400 IMX Specifications

General IconGeneral
BrandNEC
ModelNEAX 7400 IMX
CategoryServer
LanguageEnglish

Related product manuals