ND-70348 (E) CHAPTER 4
Page 231
Revision 3.0
ANPDL
3. DATA ENTRY INSTRUCTIONS
The first digit of service access code, etc.
(0-9,*,#)
1st DC
CI
BLF
1st DIGIT CODE
(1st DC)
TENANT
NUMBER
(TN)
Whether the station busy status is monitored by the system or not.
This parameter assignment is required when the Busy Lamp Field
is installed.
NND
CONNECTION STATUS INDEX
(CI)
N/H/B
NUMBER OF NECESSARY DIGITS
(NND)
MAXIMUM 6 DIGITS
BUSY LAMP FIELD
(BLF)
0/1
N=Normal(Idle)
H=Hooking
B=Busy
0=Out of Service 1=In service
The status of the “1st DC” dialed
The primarily analyzed digits, prior to the ASPAL command.
Assign necessary (Minimum) number of digits for each Access
Code Basically.
To assign diferrent number of digits (such as “Timing Start” for
Telephone numbers), assign maximum number of digits in this
parameter.
To Next Page
Loading...
Need help?
General