ND-70348 (E) CHAPTER 4
Page 277
Revision 3.0
ASDC
3. Data Entry Instructions
PFX=PFX (Prefix)
SCC=SCC (MCI, SPRINT)
KIND
Enter RA as the route advancing order
Enter the office code
RA
OFFICE
The details of this parameter are shown
below.
INPUT=Input office code can be
assigned.
ALL=All office code can be assigned.
OFLG
Enter the OPR assigned
by the AFRS command
OPR
KIND OF
SELECTION
(KIND)
TIME OF DAY
CHANGE
PATTERN
NUMBER
(TDPTN) 0-7
SELECTION
PATTERN
NUMBER
(OPR)
0-4000
ROUTE
ADVANCING
ORDER
(RA)
0-7
OFFICE CODE
(OFFICE)
200-999
DESIGNATING
DATA
(EFFECT)
OFFICE CODE
FLAG(OFLG)
INPUT/ALL
Enter data “1-7” if TDPTN/PTN is assigned by the ATCP/ACMO
command, otherwise “0”.
Different TDPTN data can be assigned to a
single OPR.
Enter the data (EFFECT) in the space of the corresponding office code. Note that
the meaning of data varies depending on the KIND parameter.
• When parameter KIND is assigned as PFX:
0=an additional digit is not required.
1=the digit "1" is required as prefix for access to an FX line.
2=the digit "1" is required as prefix for access to an FX line (display only).
• When parameter KIND is assigned as SCC:
0=the office code is not allowed for the area code dialed.
1=the office code is allowed for the area code dialed.
TDPTN
EFFECT
To Next Page
Loading...
Need help?
General