ND-70348 (E) CHAPTER 4
Page 399
Revision 3.0
ARTD
RT
FUNCTION
REMARKS
38
FA Forced Account/Forced Authorization Code
0= Check is not required
1= Check is required (For Remote Access to System)
39
BC C.O Line Idle Balance Condition.
0= Not balanced 1= Balanced
40
TCM Travel Class Mark
0= Out of Service 1= In Service
41
TDMQ Tandem Off Hook OG Queuing
0= Out of Service 1= In Service
42
TRSC Trunk Restriction class
0= Out of Service 1-15= In Service
See AEFR command.
43
BT Inter-office Busy Service
0= Out of Service 1= In Service
For CCIS voice route, assign
data “1”.
44
PRV Line Trunk Privacy
0= Privacy Out of Service
1= Privacy In Service For Busy Verification, Call Waiting, Executive
Right of Way, Paging, Dictation, Data Communication, etc.).
45
A/D Analog/Digital Line Data
0= Analog 1= Digital
Assign data “1” only for dig-
ital T1 routes or Bch of
ISDN routes.
46
CW Call Waiting Service
0= Out of Service 1= In Service
47
TPQ Priority OG Queuing
0= Out of Service 1= In Service
48
BL Detection of Blocking Signal
0=No detection 1= Detection
49
TRKS Trunk Selection Sequence
0= Select from the trunk which becomes idle first.
1= Select from the trunk which becomes idle last.
Assign this data reversing to
the mate office data. (Espe-
cially, for CCIS)
50
DPLY Number Display of D
term
between offices
0= Not given 1= Given
For CCIS voice route and
ISDN Bch route.
51
ACD 0= Out of service 1= – 0000Always assign data “0” even
ACD application.
To Next Page
Loading...
