ND-70348 (E) CHAPTER 4
Page 502
Revision 3.0
ARTI
CDN
ROUTE NUMBER
TRUNK DATA
30 RETMSG (Australia only)
Return Massage for Connect ISDN LINE
with Analog Trunk
0 = CALL PROC. + ALERT
1 = CALL PROC. + ALERT or CALL
PROC. + PROGRESS
31 ANI Timing to demand ANI Information
0 = There is no ANI demand at Incoming call
1 = After receiving 1st digit
2 = After receiving 2nd digit
3 = After receiving 3rd digit
4 = After receiving 4th digit
5 = After receiving 5th digit
6 = After receiving 6th digit
7 = After receiving 7th digit
32 SRV (Australia only)
Additional Service Selection
bit 0 = Advice of Charge (AOC)
0 = Valid 1 = Invalid
bit 1 = Malicious Call Trace (MCT)/Malicious
Call Identification (MCID)
0 = Valid 1 = Invalid
bit2-bit6 = Not used
bit7 = For TON and/or NPI
0 = Invalid 1= Valid
Note:
Input this data by a deci-
mal.
33 TON Type of Number
0 = Unknown
1 = International Number
2 = National Number
3 = Network Special Number
4 = Subscriber Number 5 = Not used
6 = Abbreviated Number
7 = Reserved for Extension
Note: This data is effective when
ARTD, INT = 4 and SRV
bit7 = 1 is assigned.
To Next Page
Loading...
Need help?
General