ND-70348 (E) CHAPTER 4
Page 763
Revision 3.0
AGSPL
SERVICE INDEX
(SID) 1-63
NO.1
56
NO.1
(Kind of Assignment Number)
Available numbers are 0-15.
This data is used to assign “Floor Service” data by the ASPF command.
Note: When programming “Floor Service” data,
ASYD SYS1 INDEX 165, bit7=1 must have been assigned.
SERVICE INDEX
(SID) 1-63
NO.2
KIND
57
NO.2
This parameter specifies the number (0-63) of the
access code being assigned for mutual Access.
This parameter serves as a counter for the access
codes being assigned.
Note: This parameter is used when assigning the
details of the service by the ASPS command.
KIND: (0-3)
This parameter specifies the Split Access Parameter Classification. The data to
be assigned here depends on how the Guest and Administration stations are
differentiated.
The Guest and Administration stations may be assigned to separate TNs, RSCs,
and/or SFCs, or they may only be differentiated by their respective designations
as Administration or Guest.
0: Administration/Guest
(Assign this if the access code is to be shared between Guest
and Administration with no correspondence to TN, RSC or SFC.)
1: TN
(Assign this is the access code is to be shared among specified TNs)
2: RSC
(Assign this is the access code is to be shared among specified RSCs)
3: SFC
(Assign this is the access code is to be shared among specified SFCs)
When SRV=SSC (Service code) , SID56 (Floor Service) is assigned;
When SRV=SSC (Service code), SID57 (Split Access) is assigned;
To Next Page
Loading...
Need help?
General