Nokia 7330 - Sdp-Using; Table 46 Show Service SDP Command Output Fields

FD 100/320Gbps NT and FX NT IHub Services Guide Services Overview
Issue: 13 3HH-11985-AAAA-TQZZA 101
Table 46 describes the command output fields.
Table 46 Show Service SDP Command Output Fields
3.17.6.4 sdp-using
Parameters sdp-id — The SDP ID for which to display information.
Default:All SDPs.
Values: 1 — 17407
far-end ip-address — Displays only SDPs matching with the specified far-end IP address.
Default: SDPs with any far-end IP address.
detail — Displays detailed SDP information.
Default: SDP summary output.
Label Description
SDP Id The SDP identifier.
Adm MTU The desired largest service frame size (in octets) that can be transmitted through this
SDP to the far-end router, without requiring the packet to be fragmented.
Opr MTU The actual largest service frame size, in octets. that can be transmitted through this
SDP to the far-end router, without requiring the packet to be fragmented.
IP address Specifies the IP address of the remote end of the GRE or MPLS tunnel defined by this
SDP.
Adm
Admin State
The desired state of the SDP.
Opr
Oper State
The operating state of the SDP.
Deliver The type of delivery used by the SDP: MPLS.
Flags Specifies all the conditions that affect the operating status of this SDP.
Signal
Signaling
The signaling protocol used to obtain the ingress and egress labels used in frames
transmitted and received on the SDP.
Last Status Change The time of the most recent operating status change to this SDP.
Last Mgmt Change The time of the most recent management-initiated change to this SDP.
Number of SDPs The total number of SDPs displayed according to the criteria specified.
Associated LSP List A list of LSPs used to reach the far-end router displays. All the LSPs in the list must
terminate at the IP address specified in the Far End field.
Item Description
(2 of 2)