Nokia 7330 - Query-Response-Interval; Table 240 Query-Response-Interval Command; Table 241 Query-Src-Ip Command

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private LAN Service
Issue: 13 3HH-11985-AAAA-TQZZA 313
5.16.6.6 query-response-interval
Table 240 query-response-interval command
5.16.6.7 query-src-ip
Table 241 query-src-ip command
Item Description
Syntax query-response-interval seconds
no query-response-interval
Context configure>service>vpls>sap>igmp-snooping
Description This command configures the IGMP query response interval. If the send-queries command is
enabled, this parameter specifies the maximum response time advertised in IGMPv2/v3
queries.
The configured query-response-interval must be smaller than the configured query-interval.
If send-queries is not enabled on this SAP, the configured query-response-interval value is
ignored.
Default 10
Parameters seconds — Specifies the length of time to wait to receive a response to the host-query
message from the host.
Values: 1 — 1023
Item Description
Syntax query-src-ip ip-address
no query-src-ip
Context configure>service>vpls>igmp-snooping
Description This command configures the specific IP source address used in IGMP queries.
The no form of the command removes the specific IP source address used in IGMP queries.
Parameters ip-address — The IP source address used in queries.