FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private LAN Service
Issue: 13 3HH-11985-AAAA-TQZZA 267
5.16.2.26 force-vlan-vc-forwarding
Table 150 force-vlan-vc-forwarding command
5.16.2.27 ignore-standby-signaling
Table 151 force-vlan-vc-forwarding command
5.16.2.28 precedence
Table 152 precedence command
Item Description
Syntax [no] force-vlan-vc-forwarding
Context configure>service>vpls>mesh-sdp
configure>service>vpls>spoke-sdp
configure>service>pw-template
Description This command forces vc-vlan-type forwarding in the data path for spoke/mesh SDPs which
have either vc-type. This command is not allowed on vlan-vc-type SDPs.
The no form of this command sets default behavior.
Default disabled
Item Description
Syntax [no] ignore-standby-signaling
Context configure>service>vpls>spoke-sdp
Description When this command is enabled, the node will ignore standby-bit received from TLDP peers for
the given spoke SDP and performs internal tasks withot taking it into account.
This command is present at endpoint level as well as spoke SDP level. If the spoke SDP is part
of the explicit-endpoint, it is not possible to change this setting at the spoke SDP level. The
existing spoke SDP will become part of the explicit-endpoint only if the setting is not conflicting.
The newly created spoke SDP which is a part of the given explicit-endpoint will inherit this
setting from the endpoint configuration.
Default enabled
Item Description
Syntax precedence [precedence-value| primary ]
no precedence
Context configure>service>vpls>spoke-sdp
(1 of 2)
To Next Page
Loading...
