FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private LAN Service
Issue: 13 3HH-11985-AAAA-TQZZA 317
5.16.6.14 starg
Table 248 starg command
5.16.6.15 version
Table 249 static command
Parameters ip-address — Specifies the IPv4 unicast address.
Item Description
(2 of 2)
Item Description
Syntax [no] starg
Context configure>service>vpls>igmp-snooping>static>group
configure>service>vpls>sap>igmp-snooping>static>group
configure>service>mesh-sdp>igmp-snooping>static>group
configure>service>spoke-sdp>igmp-snooping>static>group
Description This command adds a static (*,G) entry. This command can only be enabled if no existing
source addresses for this group are specified.
Use the no form of the command to remove the starg entry from the configuration.
Item Description
Syntax version version
[no]version
Context configure>service>vpls>sap>igmp-snooping
Description This command specifies the IGMP version. If routers run different versions of IGMP, they will
negotiate the lowest common version of IGMP that is supported by hosts on their subnet and
operate in that version. For IGMP to function correctly, all routers on a LAN should be
configured to run the same version of IGMP on that LAN.
For IGMPv3, note that a multicast router that is also a group member performs both parts of
IGMPv
Parameters version — Specifies the IGMP version number.
Values 1, 2, 3
To Next Page
Loading...
