EasyManua.ls Logo

Nokia 7330 - Damping; Table 508 Damping Command

Nokia 7330
626 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Virtual Private Routed Network Service
504
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
7.10.9.11 damping
Table 508 damping command
Description This command configures the BGP connect retry timer value in seconds.
When this timer expires, BGP tries to reconnect to the configured peer. This configuration
parameter can be set at three levels: global level (applies to all peers), peer-group level
(applies to all peers in group) or neighbor level (only applies to specified peer). The most
specific value is used.
The no form of the command used at the global level reverts to the default value.
The no form of the command used at the group level reverts to the value defined at the global
level.
The no form of the command used at the neighbor level reverts to the value defined at the
group level.
Default 120 seconds
Parameters seconds — The BGP Connect Retry timer value in seconds, expressed as a decimal integer.
Values: 1 — 65535
Item Description
(2 of 2)
Item Description
Syntax [no] damping
Context configure>service>vprn>bgp
configure>service>vprn>bgp>group
configure>service>vprn>bgp>group>neighbor
Description This command enables BGP route damping for learned routes which are defined within the
route policy. Use damping to reduce the number of update messages sent between BGP
peers and reduce the load on peers without affecting the route convergence time for stable
routes. Damping parameters are set via route policy definition.
The no form of the command used at the global level disables route damping.
The no form of the command used at the group level reverts to the value defined at the global
level.
The no form of the command used at the neighbor level reverts to the value defined at the
group level.
When damping is enabled and the route policy does not specify a damping profile, the default
damping profile is used. This profile is always present and consists of the following
parameters:
Half-life: 15 minutes
Max-suppress: 60 minutes
Suppress-threshold: 3000
Reuse-threshold 750
Default no damping

Table of Contents

Other manuals for Nokia 7330

Related product manuals