Services Overview
88
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
3.17.4.3 association
Table 19 association command
3.17.4.4 bridge-identifier
Table 20 bridge-identifier command
Item Description
Syntax association ma-index [format {icc-based | integer |string | vid | vpn-id}] name ma-name
association ma-index
no association ma-index
Context configure>eth-cfm>domain
Description This command configures the Maintenance Association (MA) for the domain
The no form of the command removes the MA index parameters from the configuration.
Parameters ma-index — Specifies the Maintenance Association (MA) index value.
Values: 1...4294967295
format {icc-based | integer | string | vid | vpn-id} - Specifies a value that represents the type
(format).
Values:
icc-based: Allows for exactly a 13 character name.
integer: 0...65535 (integer value 0 means the MA is not attached to a VID.)
string: raw ascii
vid: 0...4095
vpn-id: RFC-2685, Virtual Private Networks Identifier xxx:xxxx, where x is a value between 00
and FF. For example 00164D:AABBCCDD
Default: integer
name ma-name - Specifies a generic Maintenance Association (MA) name.
Values: 1...43 characters
Item Description
Syntax [no] bridge-identifier bridge-id
Context configure>eth-cfm>domain>association
Description This command configures the service ID for the domain association. The value must be
configured to match the service-id of the service where MEPs for this association will be
created. Note that there is no verification that the service with a matching service-id exists. This
is not used for facility MEPs as they are not tied to services.
The no form of the command removes the service ID from the domain association.
(1 of 2)
To Next Page
Loading...
