Nokia 7330 - Modifying IES Service Parameters

Internet Enhanced Service
362
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
6.8.1 Modifying IES Service Parameters
Existing IES service parameters in the CLI or NMS can be modified, added,
removed, enabled or disabled. The changes are applied immediately to all services
when the charges are applied.
To display a list of customer IDs, use the show service customer command.
Enter the parameter(s) (such as description and SAP information) and then enter the
new information.
The following displays the modified service:
*A:ALA-A>configure>service>ies# info
----------------------------------------------
ies 1000 customer 50 create
description "This is a new description"
interface "to-web" create
address 10.1.1.1/24
sap lt:1/1/5:0 create
exit
exit
no shutdown
exit
----------------------------------------------
*A:ALA-A>configure>service#
6.8.2 Deleting an IES Service
An IES service cannot be deleted until SAPs and interfaces are shut down and
deleted and the service is shutdown on the service level.
Use the following CLI syntax to delete an IES service:
configure>service#
[no] ies service-id
shutdown
[no] interface ip-int-name
shutdown
[no] sap sap-id
shutdown
The service is removed from the configuration.
6.8.3 Disabling an IES Service
You can shut down an IES service without deleting the service parameters.
configure>service> ies service-id
shutdown