FD 100/320Gbps NT and FX NT IHub Services Guide Services Overview
Issue: 13 3HH-11985-AAAA-TQZZA 85
3.17.3.7 signaling
Table 14 signaling command
3.17.3.8 shutdown
Table 15 shutdown command
Item Description
Syntax signaling {off | tldp}
Context configure>service>sdp sdp-id
Description This command specifies the signaling protocol used to obtain the ingress and egress labels in
frames transmitted and received on the SDP. When signaling is off then labels are manually
configured when the SDP is bound to a service. The signaling value can only be changed while
the administrative status of the SDP is down.
The no form of this command is not applicable. To modify the signaling configuration, the SDP
must be administratively shut down and then the signaling parameter can be modified and
re-enabled.
Default tdlp
Parameters off — Ingress and egress signal auto-labeling is not enabled. If this parameter is selected, then
each service using the specified SDP must manually configure VPN labels. This configuration
is independent of the SDP’s transport type, GRE, MPLS (RSVP or LDP).
tldp — Ingress and egress signaling auto labeling is enabled.
Item Description
Syntax signaling {off | tldp}
Context configure>service>sdp sdp-id
Description This command administratively disables an entity. When disabled, an entity does not change,
reset, or remove any configuration settings or statistics.
The operational state of the entity is disabled as well as the operational state of any entities
contained within. Many objects must be shut down before they may be deleted.
Services are created in the administratively down (shutdown) state. When a no shutdown
command is entered, the service becomes administratively up and then tries to enter the
operationally up state. Default administrative states for services and service entities is
described below in Special Cases.
The no form of this command places the entity into an administratively enabled state.
(1 of 2)
To Next Page
Loading...
