Mirror Services
614
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
8.4 Basic Mirroring Configuration
Destination mirroring parameters must include at least:
• A mirror destination ID (same as the mirror source service ID).
• A mirror destination.
Mirror source parameters must include at least:
• A mirror service ID (same as the mirror destination service ID).
• At least one source type (port) specified.
The following example displays a sample configuration of a local mirrored service
where the source and destinations are on the same device (ALA-A).
*A:ALA-A>configure>mirror# info
----------------------------------------------
mirror-dest 103 create
sap lt:2/1/25:0 create
exit
exit
no shutdown
exit
----------------------------------------------
*A:ALA-A>configure>mirror#
The following displays the mirror source configuration:
*A:ALA-A>debug>mirror-source# show debug mirror
debug
mirror-source 103
port lt:2/1/24 egress ingress
no shutdown
exit
exit
*A:ALA-A>debug>mirror-source# exit
8.5 Common Configuration Tasks
This section provides a brief overview of the tasks that must be performed to
configure local mirror services and provides the CLI command syntax. Note that local
mirror source and mirror destination components must be configured under the same
service ID context.
Each local mirrored service (Figure 36) (within the same router) requires the
following configurations:
• Specify mirror destination (SAP).
• Specify mirror source (port).
To Next Page
Loading...
