Virtual Private Routed Network Service
496
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
7.10.8.8 source
Table 491 source command
7.10.8.9 remote-ip
Table 492 remote-ip command
Item Description
Syntax source ip-address
no source
Context configure>service>interface>vprn>sap>gre-tunnel
Description This command sets the source IPv4 address of GRE encapsulated packets associated with a
particular GRE tunnel. It must be an address in the subnet of the associated public tunnel SAP
interface. The GRE tunnel does not come up until a valid source address is configured.
The no form of this command deletes the source address from the GRE tunnel configuration.
The tunnel must be administratively shutdown before issuing the no source command.
Parameters ip-address — Specifies the source IPv4 address of the GRE tunnel.
Values 1.0.0.0 — 223.255.255.255
Item Description
Syntax remote-ip ip-address
no remote-ip
Context configure>service>interface>vprn>sap>gre-tunnel
Description This command sets the primary destination IPv4 address of GRE encapsulated packets
associated with a particular GRE tunnel. If this address is reachable in the delivery service
(there is a route) then this is the destination IPv4 address of GRE encapsulated packets sent
by the delivery service.
The no form of this command deletes the destination address from the GRE tunnel
configuration.
Parameters ip-address — Specifies the destination IPv4 address of the GRE tunnel.
Values 1.0.0.0 — 223.255.255.255
To Next Page
Loading...
