Virtual Private Routed Network Service
552
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
7.10.12 Show Commands
7.10.12.1 sap-using
Table 594 sap-using command
Description This command creates a context for configuring a RIP neighbor interface.
By default, interfaces are not activated in any interior gateway protocol such as RIP unless
explicitly configured.
The no form of the command deletes the RIP interface configuration for this interface. The
shutdown command in the configure>router>rip>group group-name>neighbor
ip-int-name context can be used to disable an interface without removing the configuration for
the interface.
Default no neighbor — No RIP interfaces defined
Parameters ip-int-name — The IP interface name. Interface names must be unique within the group of
defined IP interfaces for configure router interface and configure service vprn interface
commands. An interface name cannot be in the form of an IP address. Interface names can
be any string up to 32 characters long composed of printable, 7-bit ASCII characters. If the
string contains special characters (#, $, spaces, etc.), the entire string must be enclosed within
double quotes.
If the IP interface name does not exist or does not have an IP address configured an error
message will be returned.
Item Description
(2 of 2)
Item Description
Syntax sap-using [sap sap-id]
sap-using interface [ip-address | ip-int-name]
sap-using [ingress | egress] filter filter-id
Context show>service
Description Displays SAP information.
If no optional parameters are specified, the command displays a summary of all defined SAPs.
The optional parameters restrict output to only SAPs matching the specified properties.
(1 of 2)
To Next Page
Loading...
Need help?
General
