Nokia 7330 - Configuring VPRN Protocols - OSPF

Virtual Private Routed Network Service
432
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
ecmp 2
autonomous-system 10000
route-distinguisher 10001:1
vrf-target target:10001:1
interface "to-ce1" create
address 11.1.0.1/24
sap nt:sfp:1:1 create
ingress
scheduler-policy "SLA2"
qos 100
exit
egress
scheduler-policy "SLA1"
qos 1010
filter ip 6
exit
exit
exit
static-route 6.5.0.0/24 next-hop 10.1.1.2
bgp
router-id 10.0.0.1
group "to-cel"
export "vprnBgpExpPolCust1"
peer-as 65101
neighbor 10.1.1.2
exit
exit
exit
rip
export "vprnRipExpPolCust1"
group "cel"
neighbor "to-ce1"
exit
exit
exit
no shutdown
exit
...
----------------------------------------------
*A:ALA-1>configure>service# info
For more information about the RIP protocol, refer to the ISAM Router Configuration
Guide.
7.7.6 Configuring VPRN Protocols - OSPF
Each VPN routing instance is isolated from any other VPN routing instance, and from
the routing used across the backbone. OSPF can be run with any VPRN,
independently of the routing protocols used in other VPRNs, or in the backbone itself.
For more information about the OSPF protocol, refer to the ISAM Router
Configuration Guide.
CLI syntax:
configure>service>vprn>ospf#