Nokia 7330 - IES Interface DHCP Commands; Table 340 Dhcp Command; Table 341 Gi-Address Command

Internet Enhanced Service
380
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
6.10.5 IES Interface DHCP Commands
6.10.5.1 dhcp
Table 340 dhcp command
6.10.5.2 gi-address
Table 341 gi-address command
Item Description
Syntax dhcp
Context configure>service>ies>interface
Description This command enables the context to configure DHCP parameters.
Item Description
Syntax gi-address ip-address [src-ip-addr]
no gi-address
Context configure>service>ies>interface>dhcp
Description This command configures the gateway interface address for the DHCP relay. The GI address
is needed, when the router functions as a DHCP relay, to distinguish between different
interfaces.
By default, the GI address used in the relayed DHCP packet is the primary IP address of the
interface on which the DHCP boot requests are relayed. Any primary or any secondary
address of an interface of the concerned router instance can also be specified.
Default No gi-address
Parameters ip-address — Specifies the host IP address to be used for DHCP relay packets.
src-ip-address — Specifies that this GI address is to be the source IP address for DHCP relay
packets.