Nokia 7330 - Table 280 Show Port-DB Command Output Fields

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private LAN Service
Issue: 13 3HH-11985-AAAA-TQZZA 335
Table 280 describes the command output fields.
Table 280 Show Port-DB Command Output Fields
Parameters sap sap-id — Specifies the physical port identifier portion of the SAP definition.
Values: {port-id | lag-id}:{vlanid | no-tag}
• port-id
Specifies the physical port ID in the following format:
<port-id>: <nwport-id | ltport-id>
nwport-id - <slot-address>:<port-type>:<port-num>
— slot-address - nt|nt-a|nt-b|ntio-1
— port-type - sfp | xfp |vp | eth | ieee1588 | AI
— port-num - port-number
ltport-id - lt:<rack>/<shelf>/<slot>
— lt - keyword
— rack - number identifying the rack
— shelf - number identifying the shelf
— slot - number identifying the slot
• lag-id
lag: keyword
id: 1 — 64
• vlanid
Specifies the VLAN ID to be associated with the port identified by the SAP. For v-VPLS,
the SAP VLAN ID must match the VLAN ID defined at the v-VPLS level. The null value can
also be specified, to indicate that the SAP will send and receive untagged frames. If this
SAP is not defined, untagged frames will be dropped.
The m-VPLS VLAN ID is always specified as no-tag, which is reserved for untagged L2CP
frames processed to be by the m-VPLS.
Values:
m-VPLS vlanid: no-tag
v-VPLS vlanid: 0 | 1— 4093 (0 specifies untagged frames)
sdp sdp-id - Displays the IGMP snooping port database for a specific SDP ID.
Values: 1...17407
group grp-ip-address - Displays the IGMP snooping port database for a specific multicast
group address.
Label Description
Group Address The IP multicast group address for which this entry contains information.
Mode Specifies the type of membership report(s) received on the interface for the group.
In the include mode, reception of packets sent to the specified multicast address is
requested only from those IP source addresses listed in the source-list parameter of
the IGMP membership report.
In exclude mode, reception of packets sent to the given multicast address is requested
from all IP source addresses except those listed in the source-list parameter.
Type Indicates how this group entry was learned.
If this group entry was learned by IGMP, the value is set to dynamic.
For statically configured groups, the value is set to static.
(1 of 2)
Item Description
(2 of 2)