Virtual Leased Line Services
146
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
Table 91 Show Service SDP Output Fields
4.6.6.5 sdp-using
Table 92 sdp-using command
Label Description
SDP Id The SDP identifier.
Adm MTU Specifies the desired largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to be fragmented.
Opr MTU Specifies the actual largest service frame size (in octets) that can be transmitted through
this SDP to the far-end router, without requiring the packet to be fragmented.
IP address Specifies the IP address of the remote end of the GRE or MPLS tunnel defined by this
SDP.
Adm
Admin State
Specifies the desired state of the SDP.
Opr
Oper State
Specifies the operating state of the SDP.
Deliver
Delivery
Specifies the type of delivery used by the SDP: GRE or MPLS.
Flags Specifies all the conditions that affect the operating status of this SDP.
Signal
Signaling
Specifies the signaling protocol used to obtain the ingress and egress labels used in
frames transmitted and received on the SDP.
Last Status Change Specifies the time of the most recent operating status change to this SDP.
Last Mgmt Change Specifies the time of the most recent management-initiated change to this SDP.
Number of SDPs Specifies the total number of SDPs displayed according to the criteria specified.
Associated LSP List When the SDP type is MPLS, a list of static LSPs used to reach the far-end router
displays. All the LSPs in the list must terminate at the IP address specified in the far end
field.
Item Description
Syntax sdp-using [sdp-id[:vc-id] | far-end ip-address]
Context show>service
Description Display services using SDP or far-end address options.
(1 of 2)
To Next Page
Loading...
