FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private LAN Service
Issue: 13 3HH-11985-AAAA-TQZZA 217
exit
spoke-sdp 2:22 create
exit
mesh-sdp 5:750 create
exit
mesh-sdp 7:750 create
exit
no shutdown
exit
...
----------------------------------------------
*A:ALA-3>config>service#
5.9 Service Management Tasks
This section discusses the following service management tasks:
• Modifying VPLS Service and SAP Parameters
• Enabling and Disabling VPLS Entities
• Deleting a VPLS Service or SAP
• Showing VPLS information
• Clearing VPLS operational data
• Showing VPLS SAP operational data
• Clearing SAP statistics
5.9.1 Modifying VPLS Service and SAP Parameters
You can change existing service and SAP parameters after the service or SAP is
created. The changes are applied immediately.
Some v-VPLS or m-VPLS parameters cannot be modified as long as the v-VPLS or
m-VPLS exists. In order to change these parameters, you must remove the service
and reconfigure with the new values. This includes the following service parameters:
• service id
• customer ID
• VLAN ID
For some changes, the admin state of the service or SAP must be set down. If the
admin state is set down, then the operational state of the associated port shall go
down and the state change shall propagate If an SAP is operationally down, no traffic
shall be passed in control and data plane in the SAP and the corresponding
forwarding database entries shall be flushed.
The following displays a modified m-VPLS configuration.
*A:ALA-1>configure>service>vpls# info
----------------------------------------------
description “This is a different description.”
To Next Page
Loading...
Need help?
General
