Nokia 7330 - 3.16 Global Services Command Reference; Command Hierarchies

Services Overview
76
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
•
The same DHCPv6 PD is delegated to two different devices
Duplicate PD Alarm will be cleared in the following scenarios:
• When the received IGP route is withdrawn by the IGP routing protocol
• When the lease time for a DHCPv6 PD entry expires
• When the device goes offline
• When an administrator manually clears an alarm by clearing the DHCPv6
lease-state entry using the CLI command provided.
Command: clear service id <service-id no> dhcp6 lease-state
3.16 Global Services Command Reference
3.16.1 Command Hierarchies
• Customer Management Commands
• Ethernet CFM Global Commands
• Ethernet Ring Global Commands
• Show Commands
• Tools
Note — In this scenario, the PD is not delegated to the second
device, since it is considered to be an invalid delegation.
Note 1 — For offline notification to be processed properly, it is
expected that prefix-stability is enabled in the relevant
interface.
Note 2 — DPOE offline notification will be sent to IHUB through
SNMP, and therefore SNMP context "ihub" must be configured
in Core-0.
Note 3 — When a route is received from more than one IGP
routing protocol, an alarm will be generated when an IGP route
is received, and cleared when an IGP route is withdrawn.