Nokia 7330 - Table 129 Endpoint Command; Table 130 Ignore-Standby-Signaling Command; Table 131 Revert-Time Command; Endpoint

FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private LAN Service
Issue: 13 3HH-11985-AAAA-TQZZA 255
5.16.2.6 endpoint
Table 129 endpoint command
5.16.2.7 ignore-standby-signaling
Table 130 ignore-standby-signaling command
5.16.2.8 revert-time
Table 131 revert-time command
Item Description
Syntax endpoint endpoint-name [create]
no endpoint
Context configure>service>vpls
Description This command configures a service endpoint.
Parameter endpoint-name — Specifies an endpoint name, 32 chars maximum
Item Description
Syntax [no] ignore-standby-signaling
Context configure>service>vpls>endpoint
Description When this command is enabled, the node will ignore standby-bit received from TLDP peers for
the given spoke SDP and performs internal tasks without taking it into account.
This command is present at endpoint level as well as spoke SDP level. If the spoke SDP is part
of the explicit-endpoint, it is not possible to change this setting at the spoke SDP level. The
existing spoke SDP will become part of the explicit-endpoint only if the setting is not conflicting.
The newly created spoke SDP which is a part of the given explicit-endpoint will inherit this
setting from the endpoint configuration.
Default disabled
Item Description
Syntax revert-time {revert-time | infinite}
no revert-time
Context configure>service>vpls>endpoint
Description This command configures the time to wait before reverting to primary spoke SDP.
(1 of 2)