FD 100/320Gbps NT and FX NT IHub Services Guide Virtual Private Routed Network Service
Issue: 13 3HH-11985-AAAA-TQZZA 503
7.10.9.9 auth-keychain
Table 506 auth-keychain command
7.10.9.10 connect-retry
Table 507 connect-retry command
Description This command enables the use of bi-directional forwarding (BFD) to control the state of the
associated protocol interface. By enabling BFD on a given protocol interface, the state of the
protocol interface is tied to the state of the BFD session between the local node and the remote
node. The parameters used for the BFD are set via the BFD command under the IP interface.
The no form of this command removes BFD from the associated BGP protocol peering.
Default no bfd-enable
Item Description
(2 of 2)
Item Description
Syntax auth-keychain [name]
Context configure>service>vprn>bgp
configure>service>vprn>bgp>group
configure>service>vprn>bgp>group>neighbor
Description This command configures the BGP authentication key for all peers.
The keychain allows the rollover of authentication keys during the lifetime of a session.
Default no auth-keychain
Parameters name — Specifies the name of an existing keychain, up to 32 characters, to use for the
specified TCP session or sessions.
Item Description
Syntax connect-retry seconds
no connect-retry
Context configure>service>vprn>bgp
configure>service>vprn>bgp>group
configure>service>vprn>bgp>group>neighbor
(1 of 2)
To Next Page
Loading...
Need help?
General
