Internet Enhanced Service
390
FD 100/320Gbps NT and FX NT IHub Services Guide
3HH-11985-AAAA-TQZZA Issue: 13
6.10.7.9 server
Table 360 server command
6.10.7.10 source-address
Table 361 source-address command
6.10.7.11 icmp6
Table 362 icmp6 command
Item Description
Syntax server ipv6-address [ipv6-address...(up to 8 maximum)]
Context configure>service>ies>interface>ipv6>dhcp6-relay
Description This command specifies a list of servers where requests will be forwarded. The list of servers
can be entered as IP addresses. There must be at least one server specified for DHCP relay
to work. If there are multiple servers then the request is forwarded to all of the servers in the
list.
A maximum of 8 DHCP servers can be configured.
Default No server
Parameters ipv6-address — Specify the DHCP server IPv6 address.
Item Description
Syntax source-address ipv6-address
no source-address
Context configure>service>ies>interface>ipv6>dhcp6-relay
Description This command specifies a source IPv6 address which will be used as the source IPv6 address
in all the relayed DHCPv6 messages. By default all DHCPv6 relay messages will use the
outgoing interface IPv6 address as source address.
Default no source-address
Parameters ipv6-address — Specify the source IPv6 address.
Item Description
Syntax icmp6
Context configure>service>ies>interface>ipv6
Description This command configures ICMPv6 for the interface.
To Next Page
Loading...
Need help?
General
